1605A IRIG(am) Time Code Distribution with Remote M/C

Building on the success of the 1205A IRIG B (am) Time Code Distribution amplifier, the 1605A provides additional high performance Time Code outputs, and enhances this with a full remote monitor and control interface.

With the monitor and control, a remote user can easily monitor status of each of the inputs/outputs of the unit on either RS232 or Ethernet with Telnet, web browser and SNMP interfaces. Optionally the unit can take two separate inputs into an input switch with either fully automatic or manual control.

For added flexibility, individual outputs can be enabled/disabled via remote control so that unused outputs are isolated from the alarm system.

Input and output status is immediately evident from front panel indicators of each channel. Also auto/manual selection of the auto switched input is available from the front panel key pad.

The unit provides >3V pk-pk, 50 ohm outputs, and all outputs are provided on convenient BNC connectors.

 Input frequencies 100Hz to 1MHz
 16 Time Code Outputs
 Remote Monitoring Outputs
 Remote Selection of Active Outputs
 Input Auto Switch (option)
 Low Cost
 Convenient 1U, 19″ rack mount package

Time Code Output (sixteen)  
Frequency Range 100Hz to 1MHz
Level >3V pk-pk
Load Impedance 50 ohm
Connectors BNC
Time Code Inputs  
Frequency Range 100Hz to 1MHz
Level 3V pk-pk
Output Impedance 50 ohm
Alarm Output Summary alarm
indicates failure of
any output signal
Non-alarm condition: Relay energized
(fail safe)
Connector: 9 pin D-male

Controls & Indicators  
Each Channel Green/Red LED,
Input Manual/Aut
Red LED(manual)
(if Auto switch fitted)
Keypad Manual/Auto
Channel (A/B)
Ethernet RJ 45, Rear Panel
RS232 DB9 Rear panel
Web Browser  

Environmental & Physical  
Temperature: 0° to 55° C
Relative Humidity: 0 to 95%, non-condensing
Power Requirements  
AC Input (±15%) 90 - 264 VAC, <10W
DC Input (optional)  
Dimensions (HxWxD): 1U x 19” x 16”

1605A IRIG(am) Time Code Distribution PDF DOCUMENT