1205A-MC Modulated IRIG Distribution With Remote Monitor and Control Interfac

Building on the success of the 1205A IRIG Distribution amplifier, the1205A-MC provides not only the high performance time code distribution, but enhances this with a full remote monitor and control interface.

With the added monitor and control, a remote user can easily monitor status of each of the inputs/outputs of the unit on either RS232 or Ethernet with Telnet, web browser and SNMP interfaces. Optionally the unit can take two separate inputs into an input switch with either fully automatic or manual control.
For added flexibility, individual outputs can be enabled/disabled via remote control so that unused outputs are isolated from the alarm system.

Input and output status is immediately evident from front panel indicators of each channel. Also auto/manual selection of the
auto switched input is available from the front panel key pad.
Two stages of input signal buffering are used to distribute the input signal to 12 separate output channels, and insure maximum
isolation between output signals.

 IRIG am Time Code Distribution
 Distributes IRIG A, B, D, E, G, & H
 High Channel Isolation
 12 Channel Output Distribution
 Remote Monitoring of Input/Output Levels
 Remote Selection of Active Outputs
 Dual Input with Auto Switch Option
 Low Cost
 Convenient 1U, 19″ rack mount package

Electrical  
Time Code Output (twelve)  
Code Format IRIG A, B, D, E,
G, and H
Modulation Frequency 100 Hz - 1 MHz
Modulation Ratio 3 : 1
Amplitude <6V P-P
(into 50 ohms)
Connectors BNC
Alarm Output Summary alarm
indicates failure of
any output signal
Non-alarm condition: Relay energized
(fail safe)
Connector: 9 pin D-male
Controls & Indicators  
Each Channel Green/Red LED,
Healthy/Fault
Input Manual/Auto
Red LED(manual)
Keypad Manual/Auto
Channel (A/B)
Ethernet RJ 45, Front Panel
RS232 DB9 (Rear panel)
   
Protocols(Ethernet)  
Telnet  
SNMP  
Web Browser  

Environmental & Physical  
Temperature: 0° to 55° C
Relative Humidity: 0 to 95%, non-condensing
Power Requirements  
AC Input (±15%) 90 - 264 VAC, <10W
DC Input (optional)  
Dimensions (HxWxD): 1U x 19” x 12”

1205A-MC Modulated IRIG Distribution PDF DOCUMENT